KNITTED PULLOVER SWEATER

Click For Crochet Abbreviations List

Pullover with lace pattern A wide strip of lace that runs along the V-neckline to the bottom elastic band makes this model very feminine


DIMENSIONS
S (M) L (XL)
 

YOU WILL NEED
Yarn (100% silk; 50 g / 130 m) - 11 (12) 13 (14) skeins of blue; straight knitting needles No. 4 and 4,5; circular knitting needles No. 4 60 cm long.
 

PATTERNS AND SCHEMES
 

FACE FACE
Front rows - front loops, wrong rows - wrong loops. In circular rows, knit all the loops face.
 

OPEN PATTERN
Knit according to the pattern.



2 P. TO KNIT TOGETHER FACIAL WITH TILT LEFT
1 p. Remove, as the front, knit the next loop with the front and pull the removed loop through the knitted.
 

2 P. KNITTING TOGETHER WITH A WRONG LEFT
Transfer both loops to the right knitting needle and twisting so that the second loop is in front and the first loop at the back, return to the left knitting needle and knit together on the back walls of the wrong one.
 

3 P. TYPE TOGETHER FACIAL
Knit the first item with the front one and stretch the next 2 items through the knit one.
 

3 P. KNIT TOGETHER FACIAL WITH TILT LEFT
2 p., Remove, as with face knitting, knit the next loop with the front loop and stretch the removed loops through the knitted one.
 

KNITTING DENSITY
19 p. X 26 p. = 10 x 10 cm, connected by front stitch on knitting needles No. 4.5.
 

IMPORTANT
The density of your knitting should match the given, and first of all in width. Therefore, before starting work, you should tie a sample of the pattern: dial 31 p. And knit 14 cm with the front surface. Then count the loops in the middle section of the fabricated sample 10 cm long: if there are more than 19 loops in this segment, change the needles to thicker ones, if less - to thinner ones. Knit the product on the same knitting needles as the pattern.

If the instructions indicate only one number, then it applies to all sizes.
 

COMPLETING OF THE WORK
 

BACK
On knitting needles No. 4, dial 98 (110) 114 (122) p. And knit with an elastic band = alternately 2 out., 2 persons. (1st row = out. Row). 

After 4 cm, knit with an elastic band to finish the faces. next and work to continue with facial stitching on knitting needles No. 4.5. 
 

Attention
Knit 1 out. a number of seamy ones, at the same time evenly reduce the loops so that 79 (87) 95 (103) sts remain on the knitting needles. 

When the part is 43 cm long = only 102 p. mark the middle of the part with a marker and close on both sides at the beginning of each row for armholes of 3, 2, 1, 1, 1, 1 (3, 3, 2, 1, 1, 1) 3, 3, 2, 2 , 1, 1, 1 (3, 3, 3, 2, 1, 1, 1, 1) st. = On the needles 61 (65) 69 (73)

st .  When the height of the armholes from the mark is 20 (21) 22 ( 23) cm, close for the neckline the middle 17 p. And finish both sides separately. 

To form the neck at the beginning of each row from the inner edge, close by 3, 2 p. 

Simultaneously from the outer edge, close to the shoulder bevel at the beginning of each row by 5, 6, 6 (6, 6, 7) 6, 7, 8 (7, 7, 9) p.
 

BEFORE
Knit like a back, but with a V-neck and an openwork pattern (according to the pattern) on the middle 37 p. 

Having knitted the armholes (= 1st closure of the loops) before the formation begins, divide the loops in half and finish both sides separately. At the same time, so that the number of loops on both sides is the same, knit 1 out of the loop of the previous row. and transfer the middle loop to the right side. In the following persons. next to start a decrease. 
 

Left-hand side
Knit to the last loop before 19 stitches of the pattern, 1 st. Leave on the auxiliary knitting needle before work, 2 stitches together with the front knitting, knit the stitch from the auxiliary knitting needles and stitches of the pattern to the end of the row.
 

Right side
Knit to the last 2 stitches before 19 stitches of the pattern, leave 1 sts on the auxiliary knitting needle before work, knit 1 st., Loop from the auxiliary knitting needles and knit the next stitch together with the front knit to the left, knit the stitches of the row to the end. These decreases are carried out in the following persons. row (= 4th row) and continue to perform, skipping every 6th p., i.e. in every 2nd and in every 4th r., skipping every 6th r. - total run 14 p. with decreases. 

Having tied up the shoulder bevel loops to the 1st closure (check along the back), perform the shoulder bevel, as on the back. 
 

SLEEVE
On knitting needles No. 4, dial 50 (54) 58 (62) p. And knit with an elastic band = alternately 2 out., 2 persons. (1st row = out. Row). 

After 4 cm, knit with an elastic band to finish the faces. next and work to continue with facial stitching on knitting needles No. 4.5. 
 

Attention
Knit 1 out. a number of seamy ones, at the same time evenly reduce the loops so that 39 (43) 47 (51) sts remain on the knitting needles. After 21 (23) 27 (29) p. after / before chrome. start adding 1 st on both sides with a loop. Perform these increments in each 6th p. until 65 (69) 73 (77) st on the needles. 

When the part is 42 (43) 44 (45) cm long, first close on both sides for okat at the beginning of each row for 3, 2 p., then in the next person. in a row to perform the reductions: knit 1 st., knit 2 st. together, knit to the last 3 st. on a knitting needle, 2 st. knit together with a left bend, knit 1 st. 

Repeat these reductions in each person. row until 29 pins remain on the knitting needles. Then close on both sides at the beginning of each row 2, 3, 3 p. and in the same row the remaining loops. 
 

ASSEMBLY
Sew parts on the front side with mattress and knitted seams = mattress - the longitudinal edges of the parts (= 1 r. X 1 r.), Knitted seam - the edges with closed loops. Perform shoulder seams (the seam should not be stretched), side seams and sleeve seams. Sew sleeves so that folds do not form around the sleeve.
 

Beika
On circular knitting needles No. 4, on the front side of the work (thread at work), loop evenly around the neckline (start from the right shoulder seam): 1 st. From each closed loop + 2-3 additional loops, evenly distributing them on the rounding sections; in straight sections (left side of the front) 1 p. from each row, skipping every 6th row; in sections with decreasing dial 1 p. from each row; in the corner of the V-shaped cutout 1 p. from each of 2 out. loops; On the right side of the front loop, dial as on the left (the number of loops should be a multiple of 4). 

Knit in a circle with an elastic band = alternately 2 persons., 2 out. so that in the middle 2 p. 

To form a corner in every 1st and every 2nd p., Skipping every 3rd row, perform decreases: knit up to 1 p. In front of 2 middle loops, 2 p. Knit together the front, on the other side of the middle loops 2 p. Knit together front with a slope to the left. When the width of the inlay is 3–3.5 cm, close the loops according to the figure. 




Post your comment

Information!  You need to be a member to comment. You can easily sign up from here.

0 comments