Click For Crochet Abbreviations List

DIMENSIONS
S / M (M / L) L / XL 
Width of the product for the circumference of the chest: 100 (110) 120 cm 
Length of the product: 60 (62) 64 cm



 
YOU WILL NEED
Yarn (65% extra-thin merino wool, 25% baby alpaca wool, 10% microfiber; 50 g / 110 m) - 4 (5) 6 skeins of gray, 4 (5) 6 skeins of light gray; straight knitting needles No. 3,5 and 4; circular knitting needles No. 3,5 40 cm long. 



PATTERNS

GARMENT KNITTING
Loops in all rows knit facial. 
1 front track = 2 persons. row. 



STRIP PATTERN
1 p. gray, * 2 p. light gray, 2 p. gray *. Repeat from * to * to the end of the part.



2 P. KNIT TOGETHER FACIAL WITH TILT LEFT
1 p. Remove, as with face knitting, knit the next loop with the front and pull it through the removed loop. 



1 ADDITION
Make a crochet, in the next row twist the crochet 2 times and knit as a front.



KNITTING DENSITY
24 p. X 48 p. = 10 x 10 cm, knitted with a garter stitch on needles No. 4.



IMPORTANT!
to get the product acc. size, the density of your knitting should correspond to a given, primarily in width. Therefore, before starting work, you should knit a pattern: knit the specified number to complete the initial chain of 36 p. And knit 14 cm with a garter stitch. Then count the loops in the middle section of the fabricated sample 10 cm long: if there are more than 24 loops in this segment, change the needles to thicker ones, if less - to thinner ones. 

If the instructions indicate only one number, then it applies to all sizes.



COMPLETING OF THE WORK

MIDDLE BACK
On knitting needles No. 4, dial 80 (88) 96 p. With a gray thread and knit with a garter stitch, performing strips in the indicated sequence (1st p. = Out. P.). 

After completing 24 (25) 26 gray strips, knit 40 (44) 48 stitches in the next row (= out of row, light gray stripe) and transfer the remaining 40 (44) 48 stitches to the auxiliary knitting needle. 

Knit on the first 40 (44) 48 stitches until 47 (49) 51 gray strips are connected from the lower gray strip. 

Run 2 p. light gray thread. 

On a free working needle with a gray thread, dial 40 (44) 48 p., Transfer these loops to another working needle, adding to the working loops, and continue to knit strips for 80 (88) 96 p. 

When from the lower gray strip 67 (70) 73 gray stripes will be knitted, the next faces. in a row, close the middle 40 (44) 48 p. necks and cut off the light gray thread. 

Each side should be finished separately, while continuing the pattern of stripes. 

To round out the cutout in each face. in a row to perform the reductions: knit to the last 4 stitches on the knitting needle, 2 stitches, knit together the front knit with a tilt to the left, 2 faces. 

Having completed 6 p. decreasing and tying 71 (74) 77 stripes, close the loop with gray thread. 



UPPER SIDE BACK
Draw loops from top to bottom. 

A gray thread from faces. side (thread at work) to collect 1 p. from a row with closed loops and 1 p. between the front tracks. Knit 1 out. R. facial and perform 1 increase (see description) at the end of this row to round the neck = before the last 2 p. Repeat this increase at the end of each out. row 6 times. 

In the next out. row 2 p. 



Attention!
At the same time, the last loop in each person. in a row, knit together with 1 st. from the auxiliary knitting needle (loops laid off from the middle part of the back) until 2 sts remain on the auxiliary knitting needle. Both of these stitches together with the last loop of the last strip of the pattern of the upper side of the back. Hinges to close. 



LOWER SIDE
Dial loops from the bottom up with a gray thread from the faces. sides of the work (thread at work), knitting 1 p. from a set of rows and 1 p. between persons. paths. 

Bind 1 out. R. gray thread and continue to knit a pattern of stripes. 



Attention!
At the same time, the last loop in each person. knit together with the next 1 p. of the set row of the middle part of the back: insert the needle into the set loop of the middle part of the back, draw the thread through the loop and knit it together with the last loop of the row of the lower side of the back. 

Having tied to the lateral edge of the pullover, close the loops. 



BEFORE
Knit like a back. 



LOWER SLEEVE
It fits across. 

On knitting needles No. 4, type 5 stitches with a gray thread and knit with a garter stitch, performing a pattern of stripes, as described above. 

At the end of each row with faces. dial 4 points

each side.  After 8 times 4 points each (+ the first 5 points), dial another 20 (22) 24 points and knit a pattern of stripes on all loops to a height of 23 (25) 27 gray stripes from the typesetting. 

On the next gray strip, attach a marker in the middle of the sleeve. 

Knit from the marker the same number of gray stripes as before the marker, closing 4 p. At the beginning of each out. row. 

When 5 points remain on the knitting needles, close these loops. 



TOP SLEEVE
Collect loops from the bottom up with a gray thread from the faces. sides of the work (thread at work), knitting 1 p. from the set of rows, and then 1 p. between the front tracks. 

Bind 1 out. a row of gray thread, then knit stripes. 



Attention!
After the 1st light gray strip, run on both sides after / in front of 2 chrome. 1 increase each. Repeat these increments to the end of the upper part of the sleeve in each 8th p. = through 1 gray bar. 

After tying 25 gray stripes, close the loop with a gray thread. 



KANT IN THE LOWER EDGE
On the knitting needles number 3.5 gray thread from the faces. sides of the work (thread at work) dial 1 p. from each loop of the set of rows and 1 p. between the side faces. paths. 

Bind 1 out. R.

In the next row, close the loops, as in facial knitting.



KANT ON THE LOWER EDGE OF THE SLEEVE
On the knitting needles number 3.5 gray thread from the faces. parties of work (thread at work) to collect 1 p. from each person. tracks along the lower edge of the sleeve. 

Bind 1 persons. row with out. side of work. 

In the next row, close the loops, as in facial knitting.



ASSEMBLY
Parts to connect with persons. the sides with a mattress seam are the longitudinal edges of the parts (= 1 r. of one part from 1 r. of the other part). 

Sew sleeves so that folds, folds or waves do not form around the sleeve (start in the middle of the sleeve near the shoulder seam and sew the seam down on both sides). A seam connects 1 st. With 1 persons. track. 

Make side seams and sleeve seams. 



BEIKA
On circular knitting needles No. 3.5, draw a loop from the gray thread. sides of the work (thread at work), and start at the right shoulder seam: 1 p. from each person. paths and 1 p. from each loop along the edge of the neck. 

Run 1 out. circle 

In the next circular row (= faces. Circle. R.), close the loops, as with facial knitting.