PINK SWEATER WITH DIAGONAL STRIPES

Click For Crochet Abbreviations List

The diagonal stripes on the background of the patent pattern look very impressive. At the same time, knitting such a jumper is not very difficult, the main thing here is attentiveness.

DIMENSIONS
S (M) L (XL) 
Product Width: Bust: 87 (95) 103 (111) cm 
Product Length: 63 (64) 65 (66) cm
 

YOU WILL NEED
Yarn (100% cotton; 50 g / 115 m) - 11 (12) 13 (14) skeins of pink; knitting needles number 4,5; circular knitting needles No. 4 40 cm long. 
 

PATTERNS
 

RUBBER
Knit alternately 1 person., 1 out.
 

SEMI-PATENT PATTERN
1st row (= out. Row): 1 person., * Draw 1 yarn over the knitting needle and remove the next loop, 1 person. *, Repeat from * to * to the end of the row.

2nd row: 1 person., * Knit and double crochet together, 1 out. *, Repeat from * to *, Finish: Knit and double crochet together, 1 person. 

Repeat these 2 p. until the end of work.
 

KNITTING DENSITY
20 p. X 36 p. = 10 x 10 cm, connected by a semi-patent pattern on knitting needles No. 4,5. 
 

IMPORTANT!
The knitting density should correspond to the set. Therefore, before starting work, you should knit a pattern: dial 29 p. And knit 14 cm with a semi-patent pattern. Then count the loops on the middle section of the fabricated sample 10 cm long: if this segment is more than 20 p., Change the needles to thicker ones, if less - to thinner ones. 

It is important that the density of your knitting corresponds to a given density, first of all - in width. 

If the instructions indicate only one number, then it applies to all sizes. 
 

COMPLETING OF THE WORK
 

BACK
On knitting needles No. 4,5, dial 87 (95) 103 (111) sts and knit with an elastic band (1st p. = Out. Row, start and end 1 person.). 

After 4 cm, knit with an elastic band to finish the faces. nearby. 

Continue the work with a semi-patent pattern with inclined smooth stripes, distributing the pattern loops as follows: 

1st row (= out of row): knit in a semi-patent pattern on the first 45 (49) 53 (57) sts (start and finish 1 person to make the pattern coincided with the gum pattern), 5 out. for an inclined strip, 17 p. with a semi-patent pattern (start and finish 1 faces. so that the pattern matches the gum pattern), 5 out. for an inclined strip, tie the remaining 15 (19) 23 (27) p. with a semi-patent pattern (start and finish 1 person., as in a gum pattern). 

2nd row: knit with a semi-patent pattern up to 1 p. In front of the 1st strip, 2 p. Knit together the front, 4 faces. and make 1 yarn over the knitting needle for a new loop. Knit to 1 st. In front of the 2nd strip, 2 st. Knit together the front, 4 persons., 1 crochet, knit a row to the end with a semi-patent pattern. 

3rd row: knit with a semi-patent pattern, knit the crochets according to the pattern, knit 2 stitches of each strip on the wrong side. 

4th row: knit as the 2nd row. 

5th row: knit like a 3rd row. 

In each person. In a row, continue to shift the 1st and 2nd strips by 1 point to the right, as described above. Attention: finishing strips at the left side edge, knit 2 stitches together with the front, when there is a double crochet, before the extreme loop. 

Having connected only 18 (14) 10 (6) p. with displacement of loops in faces. ranks (counted by “holes”) = 18 (14) 10 (6) “holes” (= yarn) and 1 more out. a row after the last row with an offset = only 37 (29) 21 (13) p., start the 3rd strip: 

1st row: knit with a semi-patent pattern with offset loops, until 3 sts remain on the spoke, knit 2 sts. together, make 1 double crochet, 1 person. 

2nd row: 1 person., Double crochet and the next loop from the wrong side, knit to the end of the row. 

3rd row: knit with a semi-patent pattern with offset loops, until 4 stitches remain on the spoke, 2 stitches knit together front, 1 person, 1 yarn, 1 person. 

4th row: 1 person., Double crochet and the next 2 stitches. Knit purl, knit to the end of the row. 

5th row: knit with a semi-patent pattern with offset loops, until 5 pitches remain on the spoke, 2 p. Knit together the front, 2 persons., 1 yarn, 1 person. 

6th row: 1 persons., Yarn and 3 next loops to be sewn on the wrong side, knit to the end of the row. Continue to knit in this way until a 5-point strip is formed. 

Next, on these loops, knit a strip, as described above, to include the crochets in the pattern. 

20 p. After the last yarn for the 3rd strip, start the 4th strip (last), as described for the 3rd strip. 

When the back length is 61 (62) 63 (64) cm, close the middle 25 points for the neck and finish separately on both sides. 

To round the neck, close from the inner edge at the beginning of each row 2, 2 p. 

At the same time, close from the outer edge to the shoulder bevel at the beginning of each row 9, 9, 9 (10, 10, 11) 11, 12, 12 (13, 13, 13) p.
 

BEFORE
Knit like a back, but with a deeper neck. To do this, when it remains to tie the last 11 cm (check along the back = to the last closed loops on the back), close the middle 13 p. And finish both sides separately. 

To round the neck, close from the inner edge at the beginning of each row 3, 2, 2, 1, 1, 1 p. 
 

Attention!
Having tied up the humeral bevel loops on the back to the 1st closure, close the hinge bevel loops at the front as well. 
 

ASSEMBLY
Perform shoulder seams (the seam should not be stretched). 
 

SLEEVE
Knit from the armhole from top to bottom. Count to both sides of the shoulder seam 84 (88) 92 (96) p. and do by label.

On the knitting needles No. 4,5, dial from the front of the work between marks 85 (89) 93 (97) sts. (= 1 st. From each 2nd row). 

Knit with a semi-patent pattern and perform decreases on both sides to narrow the sleeve: after / in front of the chrome. knit together with a loop of 3 p. (patent pattern according to the figure), decrease in each 10th p. 

When 45 (49) 53 (57) sts remain on the knitting needles, continue working with a semi-patent pattern without decreases and knit until the sleeve is 40 (41) 42 (43) cm long.

Then make another 4 cm with elastic and close the loops according to the figure . 

Sew sleeve seams and side seams. 
 

BEIKA
On circular knitting needles No. 4, from the front side, work on the edge of the neck of the loop, starting from the right shoulder seam: on the rounded edge of the neck of the back 5–6 p., Then 1 p. From each loop in the middle section and 5–6 p. second rounded edge. 

On direct sections of the throat of the front, dial 1 point from each 2nd p. and 1 additional loop, where 3 items are sewn at a time; in places with decreases dial 1 point from each closed loop, where 1 point is closed at a time, and 1 additional loop between closed loops. 

On the right side, dial the loops the same way (an even number of loops). 

Knit in a circle with an elastic band so that the elastic pattern matches the middle loops of the semi-patent pattern on the back and front. 

With a backing width of 3.5 cm, close the loops according to the figure.




Post your comment

Information!  You need to be a member to comment. You can easily sign up from here.

0 comments

Related Posts